Tribute LX 2WD V6-3.0L DOHC (2001)
the side air bag and safety belt pretensioner to floor connectors.
NOTE: After diagnosing/repairing a seat system the restraint system diagnostic tools must be removed before operating the vehicle over the road.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
WARNING: The tightening torque of the air bag side crash sensor retaining bolts is critical for proper system operation.
1. Install the side crash sensor.
1. Position the side crash sensor to the B-pillar.
2. Install the bolts.
3. Connect the side crash sensor electrical connector.
2. Connect the battery ground cable. For additional information, refer to BATTERY DISCONNECT.
3. With the restraint system diagnostic tools still in place at all deployable devices, prove out the air bag system. For additional information, refer to
DIAGNOSTIC INSTRUCTIONS - AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL RESTRAINT SYSTEM (SRS).
4. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY DISCONNECT.
5. Install the B-pillar trim panel. For additional information, refer to B-PILLAR TRIM PANEL.
WARNING: The air bag is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in
injury and possible violation of vehicle safety standards.
6. Remove the restraint system diagnostic tools from the passenger seat floor electrical connectors.
1. Remove the air bag from the safety belt buckle pretensioner floor electrical connector.
2. Remove the air bag from the side air bag floor electrical connector.
7. Connect the passenger seat safety belt buckle pretensioner and side air bag electrical connectors.
WARNING: The air bag is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in
injury and possible violation of vehicle safety standards.
8. Remove the restraint system diagnostic tools from the driver seat floor electrical connectors.
1. Remove the air bag from the safety belt buckle pretensioner floor electrical connector.
2. Remove the air bag from the side air bag floor electrical connector.
9. Connect the driver seat safety belt buckle pretensioner and side air bag electrical connectors.
WARNING: The air bag is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in
injury and possible violation of vehicle safety standards.
10. Remove the air bag from the air bag sliding contact electrical connector at the top of the steering column.
