300E (124.030) L6-3.0L (103.983) (1986)
21.
Lift the vehicle.
22.
Remove support between oil pan and front frame cross-member. Lower the engine and insert the Allen bolt on the right engine mount.
23.
Install modified right engine compartment side-cover.
24.
Position the cooling tube and mark the hole in the side member (Figure 5). Remove the cooling tube and drill 4.4 hole into side member.
25.
Install two-piece cooling tube and fasten to side member.
26.
Exchange towing hook flap in front bumper.
27.
Tighten the Allen bolts for the engine mount at the front frame cross member from underneath (torque 40 Mm.).
28.
Install the lower engine compartment cover.
29.
Mount the right front wheel.
30.
Lower the vehicle.
31.
Insert the hex. bolt on the left engine mount. Tighten both hex bolts on the left and right engine mount (torque 55 Nm).
Note:
The heat shield should not make side contact with the engine mount bracket and both engine mounts must be tightened tension free.
32.
Attach the air cleaner.
33.
Attach the fan shroud.
34.
Reconnect the alternator rear cover.
35.
Connect the battery.
Parts Information
In Case of Warranty:
Time Allowance
02-2213
Engine mount cooling kit, install
with replacement of engine mount 2.2 hrs. | 41/47
Damage Code
24 900 04
Installation of engine mount cooling tube and replacement of front engine mounts