300SL (129.061) L6-3.0L (104.981) (1991)
23
Install flexible drive shaft, do not change, the adjustment of the gear drive shaft set previously.
24
Engage backrest lock and check complete locking system by electrically checking the microswitches on the left and right.
Connect measuring instrument to plug board X55/3 and check both microswitches individually.
Backrest locked
Nominal value:
< 1 Ohm
Backrest released Nominal value:
Infinity Ohms
25
Screw on retainer (7), route wire and fasten with cable straps.
Continue to reinstall in opposite order.
Part 2 - Outer Side of Seat
Preliminary work:
Front seat removed. See: Service and Repair/Procedures
Side covering on backrest frame removed.
Rear covering on backrest removed.
Side covering on outside of seat cushion frame removed. See: Seat Cover/Service and Repair/Procedures