S 600 Sedan (140.057) V12-6.0L (120.982) (1996)
17
Disconnect wire cable/transmission (80) on transmission (figure D)
Note: To install and remove, position selector lever or range selector lever in position "P" and leave in position "P" when wire
cable/transmission is removed
Refer to Related Procedures, Removing and Installing Cable/Transmission For Parking Lock
18
Remove rubber boot on tunnel
19
Open cable straps behind cover on left of tunnel and remove wire cable/transmission
Installation: Attach wire cable/transmission in the bracket on the jacket tube
20
Install in reverse order
21
Adjust wire cables for parking lock interlock
Refer to Adjustments, Adjusting Wire Cables For Parking Lock Interlock See: Adjustments
Remove/Install Late Type
TRANSMISSION 722.620 # as of 001681
TRANSMISSION 722.621 # as of 001977
TRANSMISSION 722.622 # as of 0016287
CABLE TO STEERING LOCK
Removal
1. Remove cover below left of instrument panel
2. Unhook wire cable/steering lock (79) by pressing in the locking tongues and at the same time pressing (arrows) against the steering lock
figure)
3. Remove stop lamp switch
4. Unhook wire cable/steering lock (79) at the release lever (77) (arrow) (figure B)
5. Compress locking device (arrows) and at the same time push the wire cable steering lock upwards out of the mount on the pedal bearing
bracket (figure C)
6. Remove wire cable steering lock
Installation
-
Install in reverse order, noting the following information
-
Position key in steering lock in position "1"
-
Adjust wire cables for parking lock interlock
CABLE TO TRANSMISSION
Removal
1. Remove cover below left of instrument panel
2. Remove A-pillar foot well cover
3. Unscrew accelerator pedal from floor panel
4. Remove driver side floor lining complete
5. Do not fold up floor carpet, foamed insulation material cracks
6. Remove air duct for rear compartment heating