SL 500 (129.067) V8-5.0L (119.982) (1996)
Engine Mount: Service and Repair
Engine Mount
-
Intake air scoops removed. See: Powertrain Management/Fuel Delivery and Air Induction
-
Disconnect ground cable at battery, connect.
-
Remove fan shroud ring, place over fan, attach.
Installation Note: Ensure the 4 engaging points are correctly located.
-
Remove bottom engine compartment panel, install.
-
Unscrew bolts (1), screw on
Tighten to: 25 Nm.
-
Raise engine at front lifting eye, lower.
CAUTION: When raising, pay attention to accelerator control at rear and coolant hoses.
-
Unscrew bolts (2), tighten
Tighten to: 55 Nm.
-
Remove engine mount (3) with shield (4), install.
-
Remove drag link, install, refer to Steering and Suspension.
Installation Note: The anti-twist lock in the engine mount (3) must engage in the opening in the shield (4) and in the retaining slot in the engine
carrier.
-
Shields (4) on left and right are identical.