mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Dashboard / Instrument Panel > < Removal and Replacement|Page 5774
Page 1
background image

Console: Service and Repair

Console - Overhead

Removal and Installation

WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Vehicle
Jacking and Lifting. Failure to follow the instructions may result in serious personal injury.

1. NOTICE: The overhead console bracket is supported by the headliner. Failure to follow the removal procedure will damage the

headliner.

Support the headliner at the rear corner of the overhead console and pull down on that corner to remove the overhead console.

-

Disconnect the 2 electrical connectors.

2. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and

procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.

To install, reverse the removal procedure.
-

To install, make sure to align the overhead console retaining clips to the retaining clip holes in the headliner bracket.

Dashboard / Instrument Panel > < Removal and Replacement|Page 5774