Grand Marquis V8-4.6L Flex Fuel (2010)
4. Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining ear is completely engaged.
5. Attach the pressure sensor hose.
6. Connect the main seat wire harness OCSM electrical connector to the OCSM service part electrical connector.
7. Tie-strap all loose wire harnesses and electrical connectors safely aside.
All seats
10. Align the seat cushion cover to the seat cushion pad and fasten the hook-and-loop strips.
11. Position the seat cushion cover and attach the J-clips.
Seats with power lumbar
12. Connect the power lumbar switch electrical connector.
13. Attach the power lumbar switch and bezel to the seat.
Seats with manual recline
14. Install the seat backrest recliner handle.
Heated seats
15. Connect the seat cushion heater mat electrical connector.
All seats
16. Install the seat track. For additional information, refer to Seats.
17. Install the front seat backrest. For additional information, refer to Seats.
18. Install the front passenger seat. For additional information, refer to Seats.
19. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
NOTICE: To prevent system failure, the following precautions must be taken before carrying out the Occupant Classification Sensor
(OCS) system reset:
-
Make sure the voltage to the Occupant Classification System Module (OCSM) is above 8 volts and less than 18 volts.
-
Make sure the OCS system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature
within the limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during
