Mariner 2WD V6-3.0L VIN 1 (2006)
4. If equipped with a manual transmission, disconnect the clutch master cylinder feed hose.
^
Plug the clutch master cylinder feed hose.
5. Remove the reservoir.
^
Release the retaining clips on the underside of the reservoir.
^
Pull the reservoir upwards.
6. NOTE: Install new seals. Lubricate the seals with clean DOT 3 motor vehicle brake fluid.
Remove and discard the 2 seals.
7. To install, reverse the removal procedure.
^
Bleed the brake system.
^
If equipped with a manual transmission, bleed the clutch master cylinder.
