Mariner 4WD L4-2.3L VIN Z (2005)
Rear Door Latch: Service and Repair
Rear Door Latch
REAR DOOR LATCH
Removal and Installation
1. Remove the interior door handle.
2. Position the rear door glass top run aside.
1
Remove the 2 bolts.
-
To install, tighten to 8 Nm (71 lb-in).
2
Position the rear door glass top run aside.
3. Disconnect the rear door latch electrical connector.
1
Release the clip.
2
Disconnect the electrical connector.
4. Disconnect the exterior door handle actuating rod.
1
Open the clip.
2
Disconnect the actuating rod.
5. Remove and discard the 3 rear door latch bolts.
-
To install, tighten to 8 Nm (71 lb-in).
6. Remove the rear door latch from inside the door frame.
7. To install, reverse the removal procedure.