Mariner 4WD L4-2.3L VIN Z (2005)
2. Disconnect the power steering pressure switch electrical connector
3. NOTE: Drain the power steering fluid into a suitable drain pan.
Disconnect the power steering pressure line fitting nut from the power steering pump.
4. Remove the 2 lower power steering pump bolts.
5. Remove the power steering pressure line bracket nut and position the pressure line aside.
6. Release the clamp and disconnect the suction hose from the power steering pump.
7. Remove the 2 upper power steering pump bolts and remove the power steering pump.
8. If necessary, using the special tool, remove the steering pump pulley.
Installation
1. CAUTION: Install a new power steering pump pulley after the second removal and installation.
