Mariner 4WD L4-2.5L (2010)
Removal and Installation
1. Disconnect the battery. For additional information, refer to Battery Disconnect See: Service and Repair/Battery Disconnect.
2. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the generator B+ terminal nut.
-
To install, tighten to 17 Nm (150 lb-in).
4. Position the generator B+ terminal cable aside.
5. Disconnect the generator harness retainer.
6. Remove the starter solenoid terminal cover.
7. Remove the starter motor positive cable nut.
-
To install, tighten to 12 Nm (106 lb-in).
8. Remove the starter solenoid wire nut.
-
To install, tighten to 5 Nm (44 lb-in).
9. Position the starter motor terminals aside.
10. Remove the battery ground cable bolt.
-
To install, tighten to 17 Nm (150 lb-in).
11. Position the battery ground cable aside.
12. Disconnect the pin-type retainer from the left rear of the engine.
13. Disconnect the pin-type retainer from the middle of the intake runners.
14. Disconnect the pin-type retainer from the front of the engine.
15. Disconnect the clip retainer from the right front of the engine.
