Mariner 4WD L4-2.5L Hybrid (2009)
-
To install, tighten to 15 Nm (133 lb-in).
4. Disconnect the low-charge protection switch electrical connector.
5. Remove the Thermostatic Expansion Valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the passenger zone valve nut.
-
To install, tighten to 7 Nm (62 lb-in).
7. Remove the auxiliary evaporator inlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
8. Remove the receiver/drier outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
9. Disconnect the passenger zone valve electrical connector.
10. Detach the evaporator inlet line from the A/C line bracket.
11. Remove the evaporator inlet line.
12. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
13. Evacuate, leak test and charge the refrigerant system.
