Mariner 4WD V6-3.0L (2010)
Alternator: Service and Repair
Generator - 3.0L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTICE: Do not allow any metal object to come in contact with the generator housing and internal diode cooling fins. A short circuit
may result and burn out the diodes. Failure to follow this instruction may result in component damage.
Disconnect the battery.
3. Remove the 5 RH lower splash shield bolts and the 1 pin-type retainer.
-
To install, tighten to 8 Nm (71 lb-in).
4. Remove the RH lower splash shield.
5. Rotate the Front End Accessory Drive (FEAD) tensioner counterclockwise and position the accessory drive belt aside.
6. Disconnect the generator electrical connector.