Mariner 4WD V6-3.0L (2010)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Using the Engine Support Bar and Adapters, support the engine.
3. Remove the front-to-aft crossmember.
1. Remove the 2 transaxle front support insulator bolts.
-
To install, tighten to 90 Nm (66 lb-ft).
2. Remove the splash shield screw.
3. Remove the 2 front-to-aft crossmember bolts and the nut.
-
To install, tighten bolts to 90 Nm (66 lb-ft).
-
To install, tighten nut to 175 Nm (129 lb-ft).