Marquis L4-140 2.3L VIN A 2-bbl (1984)
FIGURE 5
2.
Using Figure 5, check circuits #11 (dark green/yellow dot) and #16 (red/light green stripe) to make sure they are installed properly in the
connector.
3.
If ignition coil connector is wired correctly, no further action is required. Proceed with normal (hard starting) diagnostic procedures.
4.
If the wiring for the ignition coil connector does not agree with Figure 5, remove the connector from the coil and reverse circuits #11 and #16.
Reinstall connector.
NOTE:
Until the old service stock of the 14290 wire harness is depleted, it will be necessary when installing a new 14290 wire harness on the subject
vehicle to check for crossed wires at the ignition coil connector and correct, if necessary.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP14290A84
TIME:
0.2 Hr. DLR. CODING: Basic Part No. 14290 Code: F5
