Merkur Scorpio V6-179 2.9L (1989)
a.
Discard the cotter pin.
b.
Separate the tie rod end from the spindle carrier using a tie rod end remover (T85M-3395-A) or equivalent.
Figure 2
12.
Remove the nut, washer and pivot bolt attaching the control arm to the crossmember, Figure 2.
13.
Remove the nut, front washer and cover attaching the stabilizer bar to the control arm.
14.
Remove the cotter pin and attaching nut from the lower control arm ball joint. Throw away the cotter pin.
15.
Remove the lower control arm from the vehicle.
16.
Remove the rear washer and cover from the stabilizer bar.
17.
Remove and throw away the pinch bolt from the spindle carrier.
Figure 3
a.
Insert the spindle carrier lever (T85M-3206-A) or equivalent into the carrier slot, Figure 3.
b.
Rotate the spindle carrier lever 90~.
c.
Slide the spindle carrier assembly off the strut.
d.
Remove the spindle carrier lever.
Front Brake System Repair - Assembly
