Milan FWD L4-2.5L (2010)
6. Install the exhaust Y-pipe. For additional information, refer to Exhaust System &/or Catalytic Converter.
7. Position the transaxle support insulator in place and install the lower 2 transaxle insulator-to-frame bolts.
-
Tighten to 62 Nm (46 lb-ft).
8. Position the LH front structure-to-subframe splash shield in place and install the 6 pin-type retainers.
9. Position the LH splash shield in place and install the 4 screws.
10. Install the battery and battery tray. For additional information, refer to Battery.