Milan FWD V6-3.0L (2010)
3. Position the transmission fluid cooler tubes in place and install the retainer.
4. Install the transmission fluid cooler tubes in the retainers.
5. NOTE: The power steering hose is routed between the 2 transmission fluid cooler hoses.
Position the transmission fluid cooler hoses in place.
6. NOTICE: Use care not to overstretch or extend the hose clamps as damage may occur to the hose clamp and cause a leak.
NOTICE: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the
hose. If the clamp or hose is damaged, install a new fluid cooler tube.
Connect the transmission fluid cooler hoses to the transmission fluid cooler tubes.
7. Install the lower transmission fluid cooler tube in the radiator.
-
Tighten to 20 Nm (177 lb-in).
