Milan FWD V6-3.0L (2010)
7. Remove the 2 bolts and remove the transmission fluid cooler tubes.
8. NOTE: When removing the transmission fluid cooler tubes from the retainers, do not remove the retainers from the shroud.
Remove the transmission fluid cooler tubes from the retainers.
9. Remove the transmission fluid cooler tube retainer and remove the transmission fluid cooler tubes.
Installation
1. Install new O-rings on the transmission fluid cooler tubes.
2. Install the transmission fluid cooler tubes.
-
Tighten to 10 Nm (89 lb-in).
