Milan FWD V6-3.0L (2010)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Disconnect the upper transmission fluid cooler tube from the radiator.
3. Remove the bolts and the splash shield.
4. Remove the front splash shield.
1. Remove the 2 screws.
2. Remove the 4 retainers.
3. Remove the 4 bolts and the splash shield.
5. Disconnect the lower transmission fluid cooler tube from the radiator.
6. NOTICE: Use care not to overstretch or extend the hose clamps as damage may occur to the hose clamp and cause a leak.
NOTICE: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the
hose. If the clamp or hose is damaged, install a new fluid cooler tube.
Disconnect the transmission fluid cooler hoses from the transmission fluid cooler tubes.