Milan FWD V6-3.0L (2010)
Remove the nut, 22 bolts and the main control.
14. Remove the main control transaxle separator plate.
15. Remove the 2 bolts and separate the solenoid body from the main control valve body.
Installation
1. NOTE: If cleaning the solenoid body assembly or inspecting the valves, refer to Solenoid Body Assembly See: Service and
Repair/Overhaul/6F35/Disassembly and Assembly of Subassemblies/Solenoid Body Assembly. If installing a new solenoid body assembly,
continue with this procedure.
Install the solenoid body onto the main control valve body. Install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).