Montego AWD V6-3.0L VIN 1 (2005)
9. Release the cushion trim cover retainers from the cushion frame and remove the trim cover and foam pad.
-
On assembly, the LATCH and child safety seat tether anchor must be accessible through the trim cover.
10. Remove the 8 cushion frame-to-pivot tube assembly bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
11. Remove the cushion frame joining bracket and the cushion frame.
12. Remove the bolt and the RH safety belt buckle.
-
To install, tighten to 37 Nm (27 lb-ft).
13. NOTE: Make sure the anti-rotation tab is in place before tightening fastener.
To install, reverse the removal procedure.
14. Check the active restraint system for correct operation.
