Montego AWD V6-3.0L VIN 1 (2005)
properly when inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of
injury in collisions.
1. Remove the rear seat cushion.
2. Remove the center safety belt retractor anchor nut.
-
To install, tighten to 48 Nm (35 lb-ft).
3. Remove the parcel shelf.
4. Remove the bolt and center safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
