Mountaineer 2WD V6-4.0L VIN K (2007)
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Install the selector lever cable and bracket.
^
Tighten to 40 Nm (30 ft. lbs.)
5. NOTE: If the shield is loose on the cable, replace the shield.
Install the cable shield.
4WD vehicles
6. Install the front driveshaft in the vehicle.
7. Install the front driveshaft to the transfer case.
^
Tighten to 30 Nm (22 ft. lbs.)
