Mountaineer 2WD V8-4.6L (2010)
9. Slide the driveshaft toward the rear of the vehicle, while maneuvering the front section over the top of the vehicle frame crossmember and remove
the driveshaft.
10. To install, reverse the removal procedure.
Driveshaft Slip Yoke Boot
Driveshaft Slip Yoke Boot
Removal
1. Remove the driveshaft. For additional information, refer to Driveshaft - Rear, One-Piece, 4.6L (3V) See: Driveshaft - Rear, One-Piece.
2. Index-mark the driveshaft on both sides of the driveshaft slip yoke boot.
