Sable V6-182 3.0L (1986)
replaced with new ones.
3.
Slide tripod assembly forward to expose stop ring groove, then slide stop ring into position. Ensure stop ring is fully seated in groove.
4.
Fill CV joint outer race with 3.5 ounces and CV boot with 2.5 ounces of Ford CV joint grease-high temperature No. E43Z-19590-A or equivalent.
5.
Install outer race over tripod assembly, then position boot over outer race. Ensure boot is properly seated in its groove.
6.
Remove excess grease from boot exterior. Move CV joint in or out as necessary to adjust halfshaft to length as shown in Fig. 15. After halfshaft
length has been determined, expel any built up air pressure from boot by inserting a dull screwdriver between boot and outer bearing and allowing
air to escape.
7.
Install large boot clamp with suitable crimping pliers. All right side inboard CV joints use a reusable low profile large boot clamp. Do not
install with crimping pliers.
8.
Install new circlip. Do not over expand or twist the circlip during installation. To install properly, start one end in the groove and work
the circlip over the stub shaft and into the circlip groove.
