mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Engine - Idle Rough/Stall After Cold Start|Page 1987 > < Engine - Idle Rough/Stall After Cold Start|Page 1985
Page 1
background image

Idle Speed: By Symptom

Technical Service Bulletin # 90264

Date: 901219

Engine - Idle Rough/Stall After Cold Start

 IDLE - ROUGH - 1.6L EFI - AFTER COLD START - VEHICLES BUILT AFTER 11/02/87

^

STALL - 1.6L EFI - AFTER COLD START - VEHICLES BUILT AFTER 11/02/87

Article No. 90-26-4
LINCOLN-MERCURY: 1988-89 TRACER
ISSUE:

A rough idle or stall may occur after a cold engine start. These conditions generally happen in warmer weather and when higher than 87
octane rated fuel is used. The engine may actually run lean in the brief time before the idle air bypass system starts controlling warm engine 
idle speed.

ACTION:

Confirm that only 87 octane rated fuel is being used. If the engine idle and ignition timing is correct, and there are no self test codes in the
MECS system, install a vacuum delay kit. Refer to the following procedure for service details.

Engine - Idle Rough/Stall After Cold Start|Page 1987 > < Engine - Idle Rough/Stall After Cold Start|Page 1985