Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
3. Remove the power steering pressure hose (junction block to steering gear) from the junction block.
4. Remove the two junction block bolts.
5. Remove the power steering pressure hose/junction block assembly from the top of the vehicle.
INSTALLATION
1. To install, reverse the REMOVAL procedure.
^
Tighten the lower power steering pressure hose bolt to 49-69 Nm (36-51 ft. lbs.).
NOTE: Follow the start-up procedure. See: Power Steering Pump/Service and Repair/Power Steering Pump/Start Up Procedure After Power
Steering Pump or Gear Service
