Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
INSTALLATION
1. To install, reverse the removal procedure.
^
Refer to Torque Specifications.
NOTE: Follow the start-up procedure. See: Power Steering Pump/Service and Repair/Power Steering Pump/Start Up Procedure After Power
Steering Pump or Gear Service
Pressure Hose - P.S. Pump to Junction Block
REMOVAL
1. Place a drain pan under the power steering pump.
2. Remove the lower power steering pressure hose bolt from the power steering pump. Allow the power steering fluid to drain.