Villager V6-201 3.3L SOHC VIN T SFI (1999)
9
Install all three (3) wire terminals into the new brake/turn signal bulb socket. See Figure 4.
10.
Slide the rubber grommet into the brake/turn signal bulb socket. The locating tab must fit into the recess of the socket.
11.
Attach the brake/turn signal bulb socket to the tail lamp assembly.
12.
Position the tail lamp assembly close to the installed position, then connect the tail lamp assembly wiring harness connector.
13.
Install the tail lamp assembly. Tighten the retaining screws to 5 Nm (44 lb-in).
14.
Repeat steps 2 through 13 on the opposite tail lamp assembly.
