Villager V6-201 3.3L SOHC VIN T SFI (1999)
12.
Connect the jumper harness hard-shells to their respective engine harness hard-shells.
13.
Reconnect C149 and re-secure convoluted tubing if necessary.
14.
Use tie straps to secure the jumper harness to the existing engine harness (Figure 6).
15.
Reconnect negative battery cable.
16.
Verify proper engine operation.
17.
If the engine fails to start, verify proper pin orientation on the two newly installed connectors.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
Disclaimer
