Villager V6-201 3.3L SOHC VIN T SFI (1999)
Side Air Bag: Service and Repair
Passenger Side Air Bag
REMOVAL
WARNING: The backup power supply energy must be depleted before any air bag component service is performed. To deplete the backup
power supply energy, disconnect the battery round cable and wait three minutes.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Disconnect the battery ground cable.
2. Remove the four pushpins (two shown) and the CD changer cover (if equipped) or the console compartment door.
3. Remove the ashtray/cup holder assembly.
1
Push in on the tabs (one shown).
2
Pull out on the ashtray/cup holder assembly and remove it.
