Cooper S (R53) L4-1.6L SC (W11) (2004)
/l4-1.6l_sc_(w11)/Page-1736002.png)
Release 2 bolts holding bracket to subframe.
Powerpack mounting bracket to subframe
M8 x 1.25 x 12 Screw ....................................................................................................................................................................................... 19 Nm
Remove nut, holding bracket to front subframe.
Powerpack mounting bracket to subframe
M8 nut ............................................................................................................................................................................................................... 19 Nm
Remove pump assembly.
Remove nuts (1) and bolts (2) holding bracket to pump and fit to new pump.
Powerpack to rubber mount
M6 Nut .................................................................................................................................................................................................... 8Nm ± 1 Nm
Powerpack to mounting bracket
M8 Screw torx head ............................................................................................................................................................................. 10 Nm ± 1 Nm
Change rubber mountings (3) if damaged.
With ECVT Automatic Transmission
Replacing Power Steering Pump (CVT)
Caution: Make sure all parts are absolutely clean. Seal off pipe connections with plugs. No dirt is allowed to enter the system.
Recycling:
Observe country-specific waste-disposal regulations.
Draw hydraulic fluid out of tank - do not reuse.
Install hint:
Fill hydraulic system.
Caution: Pull high voltage connector straight or damage may occur.
