Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-893002.png)
Installation:
Observe tightening sequence (1-4).
Tighten control unit on hydraulic unit
1AZ Control unit on hydraulic unit ........................................................................................................................................................................... 5 Nm
Replacement:
-
Carry out programming/coding
-
Adjustment of steering angle sensor
Version II
34 52 516 Removing and installing/replacing DSC control unit
Important:
Read and comply with notes on protection against electrostatic damage (ESD protection
Necessary preliminary tasks:
^
Remove hydraulic unit. See: 34 51 527 DSC Hydraulic Unit
Important:
Removing pump motor from valve block is not permitted!
Seal line connections with plugs (1) from control unit repair kit.
Clean control unit.
