Cooper S (R56) L4-1.6L Turbo (N14) (2009)
Release screw (1).
Tighten screw plug, timing case upper section
3AZ Screw plug, timing case upper section
M22x1.5 ............................................................................................................................................................................................................ 35 Nm
Release central bolt (3).
Tighten Bedplate, observe tightening specification
2AZ Bedplate, observe tightening specification.
M6
Jointing torque ..................................................................................................................................................................................................... 9 Nm
Note: Replace screws
Feed out sprocket wheel (2) from timing chain (1) towards front.
Release central bolt (3).
Tighten main bearing screws, observe tightening specification.
1AZ Main bearing screws, observe tightening specification.
M9x115