Diamante V6-3.5L SOHC (2003)
<B> AIR BAG MODULE REMOVAL (DRIVER'S SIDE)
When disconnecting the connector of the clock spring from the air bag module, press the air bag's lock toward the outer side to spread it open. Use a
flat-tipped screwdriver, prying gently as shown in the figure, to remove the connector.
CAUTION: When disconnecting the air bag module-clock spring connector, take care not to apply excessive force to it.
CAUTION: The removed air bag module should be stored in a clean, dry place with the pad cover face up.
<C> STEERING WHEEL REMOVAL
CAUTION: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.
<D> CLOCK SPRING REMOVAL
CAUTION: The removed clock spring should be stored in a clean, dry place.
<E> AIR BAG MODULE REMOVAL (FRONT PASSENGER'S SIDE)
CAUTION: The removed air bag module should be stored in a clean, dry place with the pad cover face up.
INSTALLATION SERVICE POINTS
>A< PRE-INSTALLATION INSPECTION
1. When installing the new air bag modules and clock spring, refer to "INSPECTION".
CAUTION: Dispose of air bag modules only according to the specified procedure.
2. Connect the battery (-) terminal.
3. Connect the scan tool to the data link connector.
CAUTION: Turn off the ignition switch before connecting or disconnecting the scan tool.
4. Turn the ignition key to the "ON" position.
5. Conduct diagnostic test using the scan tool to ensure entire SRS operates properly.
6. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
