Diamante V6-3.5L SOHC (2003)
>B< CLOCK SPRING INSTALLATION
Align the mating marks of the clock spring and, after turning the front wheels to the straight ahead position, install the clock spring to the column switch.
Mating Mark Alignment
Turn the clock spring clockwise fully, and then turn it back approx. 3 4/5 turns counterclockwise to align the mating marks.
CAUTION: If the clock spring's mating marks are not properly aligned, the steering wheel may not rotate completely during a turn, or the flat cable
within the clock spring may be severed, obstructing normal operation of the SRS and possibly leading to serious injury to the vehicle's driver.
>C< STEERING WHEEL INSTALLATION
1. Before installing the steering wheel, be sure to first turn the vehicle's front wheels to the straight-ahead position and align the mating marks of the
clock spring.
CAUTION: Be sure when installing the steering wheel, that the harness of the clock spring does not become caught or tangled.
2. After securing the steering wheel, turn the steering wheel all the way in both directions to confirm that steering wheel rotation is normal.
>D< POST-INSTALLATION INSPECTION
1. Turn the ignition key to the "ON" position.
2. Does the "SRS" warning light illuminate for about 7 seconds, and then remain off for at least 5 seconds after turning off?
3. If yes, SRS system is functioning properly. If no, consult See: Testing and Inspection
