Diamante Sedan V6-3.5L SOHC (1999)
2. Remove the wheel bearing inner race from the front hub by using the special tool, as shown in the illustration.
3. Drive the wheel bearing out with a press, using a 61 mm (2.4 inch) installer adapter.
Service Points Of Reassembly
>A< Wheel Bearing
1. Fill the wheel bearing with multipurpose grease.
2. Apply a thin coating of multipurpose grease to the knuckle and bearing contact surfaces.
3. Press-in the bearing using the special tools.
>B< Oil Seal (Hub Side)
1. Drive the oil seal (hub side) into the knuckle by using the special tools until it is flush with the knuckle end surface.
2. Apply multipurpose grease to the lip of the oil seal and to the surfaces of the oil seal which contact the front hub.
>C< Installing Hub (On To Knuckle)
1. Use the special tool to mount the hub on to the knuckle.
