Eclipse L4-2.4L SOHC (2004)
STEP 3. Check high-beam indicator light bulb.
Q: Is the high-beam indicator light bulb in good condition?
YES: Go to Step 4.
NO: Replace the high-beam indicator light bulb. Check that the high-beam indicator light illuminates normally.
STEP 4. Check the combination meter (printed-circuit board).
1. Remove the combination meter. Refer to Combination Meter Assembly and Vehicle Speed Sensor.
2. Remove the high-beam indicator light bulb. Then measure the resistance value between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance value between connector C-42 terminals 21 and 22. The measured
resistance value should be roughly the same as the value measured in Step (2).
Q: Are these two resistance values extremely different?
YES: Repair or replace the combination meter (printed circuit board). Check that the headlight-beam indicator light illuminates normally.
NO (much the same): Go to Step 5.
STEP 5. Check combination meter connector C-42 in order to check the ignition switch (IG1) line of the power supply to the high-beam
indicator light.
1. Disconnect combination meter connector C-42, and measure at the wiring harness side.
