Eclipse V6-3.0L SOHC (2003)
STEP 4. Check the wiring harness between hazard warning light switch connector C-10 (terminal 2) and ground.
Q: Is the wiring harness between hazard warning light switch connector C-10 (terminal 2) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
STEP 5. Check hazard warning light switch connector C-10 and ETACS-ECU connector C-118 for damage.
Q: Are hazard warning light switch connector C-10 and ETACS-ECU connector C-118 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the hazard warning light switch should be normal.
