Eclipse V6-3.0L SOHC (2003)
STEP 6. Check the wiring harness between hazard warning light switch connector C-10 (terminal 1) and ETACS-ECU connector C-118
(terminal 55).
Q: Is the wiring harness between hazard warning light switch connector C-10 (terminal 1) and ETACS-ECU connector C-118 (terminal 55) in good
condition?
YES: Replace the ETACS-ECU. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
NO: Repair the wiring harness. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
Inspection Procedure P-3
The ETACS-ECU Does Not Receive Any Signal From The Driver's Seat Belt Switch.