mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2549 > < Initial Inspection and Diagnostic Overview|Page 2547
Page 485
background image

1. Disconnect liftgate latch switch connector F-16 <ECLIPSE-Vehicle with theft-alarm system> or trunk lid latch switch connector F-16 <ECLIPSE

SPYDER-Vehicle with theft-alarm system> and measure at the harness side.

2. Measure the resistance between terminal 2 and ground.

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 5.

NO: Go to Step 3.

Initial Inspection and Diagnostic Overview|Page 2549 > < Initial Inspection and Diagnostic Overview|Page 2547