mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2109 > < Initial Inspection and Diagnostic Overview|Page 2107
Page 192
background image

NO: Replace the rear side marker light bulb (LH). Check that the rear side marker light (LH) illuminate normally.

STEP 37. Measure at rear side marker light (LH) connector F-20 in order to check the ground circuit to the license plate lights.

1. Disconnect rear side marker light (LH) connector F-20, and measure at the wiring harness side.

2. Measure the resistance value between terminal 1 and ground.

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 40.

NO: Go to Step 38.

STEP 38. Check rear side marker light (LH) connector F-20 for damage.

Q: Is rear side marker light (LH) connector F-20 in good condition?

YES: Go to Step 39.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the rear side marker light (LH) illuminate normally.

Initial Inspection and Diagnostic Overview|Page 2109 > < Initial Inspection and Diagnostic Overview|Page 2107