mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2108 > < Initial Inspection and Diagnostic Overview|Page 2106
Page 191
background image

STEP 35. Check the wiring harness between rear combination light (RH) connector F-09 and front-ECU connector A-10X.

NOTE:  Also check intermediate connector C-89, junction block connectors C-101 and C-112. If intermediate connector C-89, junction block connector
C-101 or C-112 is damaged, repair or replace the connector as described in Harness connector Inspection.

Q: Is the wiring harness between rear combination light (RH) connector F-09 and front-ECU connector A-10X in good condition?

YES: Replace the rear combination light socket assembly (RH). Check that the tail light (RH) illuminates normally.

NO: Repair the wiring harness. Check that the tail light (RH) illuminates normally.

STEP 36. Check the rear side marker light bulb (LH).

1. Remove the rear side marker light bulb (LH).
2. Check that the rear side marker light bulb (LH) is not broken.

Q: Is the rear side marker light bulb (LH) in good condition?

YES: Go to Step 37. 

Initial Inspection and Diagnostic Overview|Page 2108 > < Initial Inspection and Diagnostic Overview|Page 2106