Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 7. Check the wiring harness between driver's door lock actuator switch connector E-13 and ETACS-ECU connector C-117.
NOTE: Also check intermediate connector C-91. If intermediate connectors C-91 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between driver's door lock actuator switch connector E-13 and ETACS-ECU connector C-117 in good condition?
YES: Replace the ETACS-ECU. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the driver's
door lock actuator switch should be normal.
NO: Repair the wiring harness. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the driver's
door lock actuator switch should be normal.
STEP 8. Check the front passenger's door lock actuator switch.
Disconnect front passenger's door lock actuator switch connector E-07. Then check continuity between the switch terminals.
Q: Is the front passenger's door lock actuator switch in good condition?
YES: Go to Step 9.
NO: Replace the front passenger's seat door lock actuator switch. If the functions, which are described in "CIRCUIT OPERATION", work normally,
the input signal from the front passenger's door lock actuator switch should be normal.
STEP 9. Measure at front passenger's door lock actuator switch connector E-07 in order to check the ground circuit to the front passenger's
