Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
door lock actuator switch.
1. Disconnect front passenger's door lock actuator switch connector E-07, and measure at the harness side.
2. Measure the resistance value between terminal 3 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 12.
NO: Go to Step 10.
STEP 10. Check front passenger's door lock actuator switch connector E-07 for damage.
Q: Is front passenger's door lock actuator switch connector E-07 in good condition?
YES: Go to Step 11.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the functions, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the front passenger's door lock actuator switch should be normal.
