Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 9. Measure at power window sub switch connector E-05 in order to check the ground circuit to the power window sub switch.
1. Disconnect power window sub switch connector E-05, and measure at the harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 12.
NO: Go to Step 10.
STEP 10. Check power window sub switch connector E-05 for damage.
Q: Is power window sub switch connector E-05 in good condition?
YES: Go to Step 11.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the central door locking system works normally, input signal from the
door lock switch should be normal.
