Endeavor 2WD V6-3.8L (6G75) (2008)
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (4) C-101 and combination meter connector C-102, and measure the resistance between each wiring harness side
connector.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.
4. Measure the resistance between joint connector (4) terminal 4 and combination meter connector terminal 15.
OK: 2 ohms or less