Endeavor 2WD V6-3.8L (6G75) (2008)
5. Measure the resistance between joint connector (4) terminal 15 and combination meter connector terminal 14.
OK: 2 ohms or less
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Do all the resistances measure 2 ohms or less?
YES : [All the resistances measure 2 ohms or less] Power supply to the combination meter may be suspected. Diagnose the combination meter by
referring to Chassis Electrical, Combination meter assembly.
NO : [If either of the resistances measures more than 2 ohms or all the resistances measure more than 2 ohms] Repair the wiring harness between
joint connector (4) and the combination meter connector.
STEP 8. Check ETACS-ECU connector C-218 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twist wire should be within 10 cm (4 inches) from the connector.