Lancer L4-2.4L SOHC (2005)
STEP 11. Check the wiring harness between power window main switch E-05 (terminal 8) and ground.
NOTE: Also check intermediate connector C-17 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-17 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between power window main switch connector E-05 (terminal 8) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the power windows work normally.
STEP 12. Check the battery power supply circuit to the power window main switch. Measure the voltage at power window main switch
connector E-05.
1. Disconnect power window main switch connector E-05 and measure the voltage available at the wiring harness side of the connector.
